by N3tmine_Admin | May 10, 2022
The Triton silencers are all designed to be as maintenance-free as possible. There are, however, a few things that are important to remember: Burning powder leaves residues, among those water that reacts and creates ammonium. Therefore – always remove the silencer...
by N3tmine_Admin | May 10, 2022
Measure the diameter of the barrel where the thread is to be cut. Remember that the diameter normally increases backwards – good to know if you are planning on cutting the barrel before making the thread. A rule of thumb is that there shall be an edge (shoulder) of...
by N3tmine_Admin | May 10, 2022
Metric threads with the rise of 1 mm/round are the most common. Some time ago a 1.5mm rise was commonly used but the thread with the 1.0mm rise increase the contact surface as well as does not cut so deep as the 1.5mm. Imperial threads UNF (fine) correspond to the...
by N3tmine_Admin | May 10, 2022
Cartridges such as .308Win, 8×57, 9.3X57 (also 9.3×62), 45-70, 30-06 can be cut, but a certain reduction in velocity must be expected. There are of course other calibers that accept shorter barrels without losing too much speed, but the basic rule is to...
by N3tmine_Admin | May 10, 2022
With a silencer, the speed of the bullet usually increases slightly.
